This wiki is intended for older versions of Motive. For the latest documentation, please refer to
docs.optitrack.com

Properties: Force Plates

Main PageProperties paneProperties: Force Plates

When a force plate is selected in Motive, its device information gets listed under the Properties pane. For configuring force plate properties, use the Devices pane and modify the corresponding device properties.

For more information, read through the force plate setup pages:

Info2.png

Advanced Settings

The Properties: Force Plates contains advanced settings that are hidden by default. Access these settings by going to the menu on the top-right corner of the pane and clicking Show Advanced and all of the settings, including the advanced settings, will be listed under the pane.

The list of advanced settings can also be customized to show only the settings that are needed specifically for your capture application. To do so, go the pane menu and click Edit Advanced, and uncheck the settings that you wish to be listed in the pane by default. One all desired settings are unchecked, click Done Editing to apply the customized configurations.

AdvancedSettings 30.png

Settings


Force Plate properties in Motive. (AMTI)

Info2.png

Force Plate Group Properties:

Group policy is enforced for the force plates that are from the same vendors. This means most of the force plate properties are shared within the force plate groups. Shared settings include the enabled status, sampling rates, and sync modes. These settings should be configured the same for all force plates in most cases. If you need to disable a specific force plate among the group, this will need to be done by powering off the amplifier or disabling the device from the Windows Device Manager.

Enabled

Enables or disables selected force plate. Only enabled force plates will be shown in Motive and be used for data collection.

Triggered Sync

Select whether the force plate is synchronized through a recording trigger. This must be set to Device when force plates are synchronized through recording trigger signal from the eSync. This must be set to None when synchronizing through a clock signal.

Reference Clock Sync

When set to true, the force plate system synchronizes by reference to an external clock signal. This must be enabled for the reference clock sync. When two systems syncs using the recording trigger, this must be turned off.

eSync Output

Indicates the output port on the eSync that is used for synchronizing the selected force plate. This must match the output port on the eSync that is connected to the force plate amplifier and sending out the synchronization signal.

Multiple

Multiplier applied to the camera system frame rate. This is available only for triggered sync and can also be configured from the Devices pane. The resulting rate decides the sampling rate of the force plates.

Rate

Resulting data acquisition rate of the force plates. For reference clock sync setups, it will match the frequency of the clock signal. For triggered sync setups, this will match the multiple of the camera system frame rate.

Order

Assigned number of the force plates.

Device Asset

Name of the Motive asset associated with the selected device. For Manus Glove integration, this must match the name of the skeleton.

Details


Name

Name of the selected force plate.

Model

Model number of the force plate

Serial

Force plate serial number.

Channels

Number of active channels available in the selected device. For force plates, this defaults to 6 with channels responsible for measuring 3-dimensional force and moment data.

State

Indicates the state that the force plate is in. If the force plate is streaming the data, it will be indicated Receiving Data. If the force plate is on standby for data collection, it will be indicated Ready.

Scale

Size scale of the resultant force vector shown in the 3D viewport.

Length

Length of the force plate.

Width

Width of the force plate.

ElectricalOriginOffset

Manufacturer defined electrical-to-mechanical offset values.

Corners

Lists out positions of the four force plate corners. Positions are measured with respect to the global coordinate system, and this is calibrated when you Set Position using the CS-400 calibration square.